Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. DMX 512 Connection
1.
Connect the provided XLR cable to the male 3-pin
XLR output of your controller and the other side to the
female 3-pin XLR input of the light.then connect the DMX
signal to the first fixture to the 2nd fixture, a er all fixtures
are connected,
2.
The signal cable should be two - core with
screened cable with XLR input and output connectors.
Please refer to the diagram below.
5-Pin DMX output
3-Pin DMX output
DMX terminator connection
If there are many lines or lights, it is recommended to use a
DMX terminator to prevent DMX signal corruption, the DMX
terminator is an simple XLR plug with a 120
nected between pins 2 and 3,which is then plugged into
the output XLR socket of the last fixture in the chain.
5in DMX input
3in DMX input
resistor con-
1. Ground
2. Signal -
3. Signal +
4. None
5. None
1. Ground
2. Signal -
3.Signal +
Weld a 120 ohm resistor
between 2 and 3 pins
male XLR , and insert it
into the signal output of
the last device
P. 11
NEBULA FX 3 IN 1
ENGLISH VERSION
Tabla de contenido
