Festool DWC 18-2500 Manual De Instrucciones página 17

Attach the depth stopper on the bit (see figure
.
By means of jamming the depth stopper with
the bit and concurrent pulling, it is possible to
pull out the bit.
Then attach a new bit in the holder.
Pressing only the switch
machine –
Upon screwing to the required depth, the power
tool switches off!
The machine can be switched on by means of sev-
eral methods:
Set the forward / reverse switch
chine clockwise operation.
Set the switch
In order to switch on the power tool, apply the
switch and concurrently press the bit on
the screw.
Use the switch
speed.
Set the forward / reverse switch
chine clockwise operation.
Set the switch
Press the bit on the screw and the power tool
will switch on.
Switch does not need to be pressed. Maxi-
mum speed is set automatically.
Set the forward / reverse switch
chine anti-clockwise operation.
In order to start the power tool, press the switch
.
The switch MAN/AUTO
Use the switch
speed.
If the forward / reverse switch is set to anti-
clockwise operation, the screwdriver can be
started only by pressing the switch
additional pressure on the bit.
It is not necessary to remove the depth stopper
in order to unscrew screws.
does not start the
!
into ma-
into MAN position.
to gradually regulate the
into ma-
into AUTO position.
into ma-
is in any position.
to gradually regulate the
without
Turning the depth stopper
depth – see figure
prox ± 0,1 mm.
Anti-clockwise screws are inserted deeper
rotation
Clockwise rotation screws are inserted to lower
depth
Upon setting the depth, set some screws to test and
adjust the depth.
Fit the depth stop
Press until it engages in the groove.
Remove the depth stop from the gear box by
pulling it.
Use the belt clip
screwdriver on the working clothing – it can be at-
tached by means of a screw
of the power tool, and it is suitable for right and left
handed people – see figure
The screwdriver is equipped with a scaffolding
holder which is used for occasional machine
suspension. It can be attached to the left or right of
the power tool, by means of a screw
ure .
The magazine attachment enables to work contin-
uously, without unnecessary delays.
At first remove the depth stopper
bit holder as specified in chapter 8.
Set the switch
Push the long bit
onal spindle opening
Then fit the magazine attachment on the gear
box. Push the attachment until it engages in the
groove of the gear box.
The attachment can be mounted at 30° steps.
Use power to carefully pull the magazine at-
tachment from the gear box.
Press button
depth stop and set the required screw
length.
D U R A D R I V E
sets the screwing
. The setting accuracy is ap-
on the gear box
to temporarily attach the
to the left or right
.
– see fig-
and bit,
into MAN position.
completely to the hexag-
.
to remove and insert the
GB
.
17