GB
D U R A D R I V E
Bit store
On/Off switch
Right/left switch
AUTO/MAN switch
Depth stop
Bit
Insulated gripping surfaces (grey shaded
area)
LED-Display
Cable holder
Wall mount for charger
Accessories shown or described are sometimes not
included in the scope of delivery.
The specified illustrations appear at the beginning
of the Operating Instructions.
Unwind the cable completely from the recess
before using the charger.
Battery pack is ready for use immediately upon
delivery and can be charged at any time.
The LED
on the charger indicates the respec-
tive operating status of the charger.
Charger is ready to use.
Battery pack is charged to maxi-
mum capacity.
Battery pack is charged with
reduced current. Li-ion is
charged to 80 %.
Charging is complete or is not
restarted as current charge sta-
tus is greater than 80%.
General fault indication, e.g.
incomplete contact, short circuit,
defective battery pack, etc.
16
Battery temperature is outside
the permitted range.
Always switch off the power tool before adjusting
settings!
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation
Always disconnect the battery pack before per-
forming any type of work on the machine!
The bit holder is used for fast replacement of bits.
Do not use insert tools that are blunt or defec-
tive.
Wear protective gloves.
Set the switch
Set the bit holder
onal spindle opening
Attach bit into the holder
Then attach the depth stopper on the gear box
as specified in chapter 9.2.
Remove the depth stopper as specified in chap-
ter 9.2.
Use power to pull out the holder from the spin-
dle opening.
You can use the depth stopper
placement
.
into MAN position.
completely to the hexag-
.
.
for the bit re-