Install Cord Bracket And Casters; Install Vent System - Kenmore 110.84422610 Manual De Uso Y Cuidado

Special provisions for mobile home installations
The exhaust vent must be securely fastened to a noncombustible
portion of the mobile home structure and must not terminate
beneath the mobile home. Terminate the exhaust vent outside.
Determine vent path
Select the route that will provide the straightest and most
■
direct path outdoors.
Plan the installation to use the fewest number of elbows
■
and turns.
When using elbows or making turns, allow as much room
■
as possible.
Bend vent gradually to avoid kinking.
■
Use the fewest 90° turns possible.
■
Determine vent length and elbows needed for best drying
performance
Use the "Vent System Chart" below to determine type of vent
■
material and hood combinations acceptable to use.
NOTE: Do not use vent runs longer than those specified in
the "Vent System Chart." Exhaust systems longer than those
specified will:
Shorten the life of the dryer.
■
Reduce performance, resulting in longer drying times and
■
increased energy usage.
The "Vent System Chart" provides venting requirements that will
help to achieve the best drying performance.
Vent System Chart
Number of Type of vent
90° turns
or elbows
0 Rigid metal
1 Rigid metal
2 Rigid metal

Install Vent System

1. Before installing the vent system, be sure to remove the wire
exhaust guard that is located at the exhaust outlet.
8
Box or Angled hoods
louvered
hoods
36 ft (11 m) 26 ft (7.9 m)
26 ft (7.9 m) 16 ft (4.9 m)
16 ft (4.9 m) 6 ft (1.8 m)
2. Install exhaust hood.
Install exhaust hood and use caulking compound to seal
exterior wall opening around exhaust hood.
3. Connect vent to exhaust hood.
Vent must fit inside exhaust hood. Secure vent to exhaust hood
with 4" (102 mm) clamp. Run vent to dryer location. Use the
straightest path possible. See "Determine vent path" in "Plan
Vent System." Avoid 90° turns. Use clamps to seal all joints.
Do not use duct tape, screws, or other fastening devices that
extend into the interior of the vent to secure vent, because they
can catch lint.

Install Cord Bracket and Casters

Do not move dryer into its final location until the following steps
have been performed.
Install cord bracket
1. Remove tape from the power cord and the rear panel.
2. Insert cord brackets into slotted holes in rear panel and
secure with screws provided.
A. Cord bracket
B. Slotted hole
C. Screw
NOTE: Power supply cord may be wrapped around the brackets
for storage convenience when dryer is not in use.
12" min.
(305 mm)
12" min.
(305 mm)
A
B
C