Kenmore 110.84422610 Manual De Uso Y Cuidado página 15

First try the solutions suggested here for assistance and to possibly avoid a service call.
If you experience
Dryer Results (cont.)
Cycle time is too short
Lint on load
Stains on load
Stains on drum
Loads are wrinkled
Odors
Accessory
For ordering information, see the back page.
Part Number Accessory
49971 Compact dryer stand – white
TROUBLESHOOTING
Possible Causes
The sensor cycle is ending early.
Lint screen is clogged with lint.
Improper use of fabric softener.
Loose dyes in clothes.
The load was not removed from dryer
at the end of the cycle.
The dryer was tightly packed.
Recent painting, staining, or varnishing
in the area where your dryer is
located.
Dryer being used for the first time.
Change the dryness level setting on sensor cycles. Increasing or
decreasing the dryness level will change the amount of drying
time in a cycle.
Clean lint screen before each load.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by unstable dyes in clothing (usually blue
jeans). These will not transfer to other clothing. Dry unstable dye
items like blue jeans inside-out to avoid transfer of dye to drum.
Refer to garment care label instructions. Dry-clean-only garments
are not recommended.
Dry smaller loads that can tumble freely.
Ventilate the area. When the odors or fumes are gone from the
area, rewash and dry the clothing.
The new electric heating element may have an odor. The odor will
be gone after the first cycle.
Solution
15