Chapter 7 Preparations Before Operation; Chapter 8 Notes During Operation - Gima 33232 Manual De Uso

6.1.9 Use the neutral solvent to clean lead cables, do not use any detergent or germi-
cide containing alcohol.
6.1.10 Please make sure the temperature of operating environment is within +5°C
~+40°C. If the device is stored in relative high/low temperature, place it in the
operating environment for about 1O minutes before use, in order to achieve nor-
mal performance.
6.2 Cautions during operating
6.2.1 For the ECG waveform printing, it shall be started after the waveform is stable.
Do not touch the printer during printing process.
6.2.2 Doctors should not leave when operating the device. To ensure patient safety,
doctors shall keep observing the patient, shutdown the power or remove the
electrodes if necessary.
6.2.3 The patient can connect with the device only by electrodes of lead cables, and
avoid touching with other parts or conductors on device.
6.2.4 Patient shall not move when the device is running.
6.3 Cautions after use
6.3.1 Set all the functions as initial state, then shutdown the device.
6.3.2 Cut the power off, gently remove the electrodes and limb clips, then take away
the lead cables, do not pull the cables with force.
6.3.3 Clean the device and its accessories, store it in proper place for further use.
Chapter 7
PREPARATIONS BEFORE OPERATION
7.1 Check whether the instrument is grounded properly and cable connection is safe
or not.
7.2 Make sure all electrodes connected directly with patient are proper and firm.
7.3 The conductive gel cost should be separate with each other, and it is same for
chest electrodes, in order to avoid the short circuit.
7.4 AC power cable can not be enlaced with ECG cable.
7.5 Don't use water pipe or other pipes as earth line. Fine grounding can not only en-
sure safety, but also reduce AC interference and other electromagnetic interference.
Chapter 8
NOTES DURING OPERATION
8.1 Pay attention to the patient and device status at any moment.
8.2 Patient and device can only be connected through ECG lead cables.
8.3 Keep close observation of the patient and device to make sure they are still during
operation.
8.4 Turn off the device after using.
8.5 Disconnect the power, and remove the ECG lead cables gently without strong
force.
ENGLISH
50