Tabla de contenido
Idiomas disponibles
Idiomas disponibles
AFTER EACH USE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump
parts and "freeze" pump action. FolJow these
procedures after every use:
1.
Flush chemical system by turning its chemical
shut-off vaJves to "Off" position and run pressure
washer with black spray tip. Flush for one to two
minutes.
2.
Shut off engine, Jet it cool, then remove aJJhoses.
3.
Disconnect spark plug wire from spark pJug.
4.
Empty pump of aJJJiquids by puJJing recoil handJe
about 6 times. This should remove most liquid in
pump.
5.
if storing for more than 30 days see "Long Term
Storage" on next page.
6.
Uncoil high pressure hose and inspect it for
damage. Cuts in hose or fraying could result in
leaks and loss of pressure. Should any damage
be found, replace hose. DO NOT attempt to repair
a damaged hose. Replace hose with genuine
Sears part.
7.
Disconnect hose from spray gun and high
pressure outlet on pump. Drain water from hose,
gun, and nozzle extension. Use a rag to wipe off
hose.
8.
Slide one end of hose into hole on hose reel. Turn
hose reel with handle to coil hose onto reel.
9.
Reconnect spark plug wire to spark plug.
10. Store unit in a clean, dry area.
WARNING!
NEVER store the engine with fuel
in the gas tank indoors or in enclosed, poorly
ventilated areas where fumes may reach an
open flame, a spark, or pilot light.
WINTER
STORAGE
CAUTION
• Failure
to do so will permanently
damage
your pump
and render
your
unit inoperable,
• Freeze
damage
is not covered
under warranty.
To protect the unit from freezing temperatures:
1.
Empty aJJchemicaJ reservoirs as follows:
a.
Disconnect hose connected to chemical inject
fitting on pump. PJace end of hose into
suitable container.
b.
Rotate one of the chemical shut-off valves to
"On" position and open that tanks cover.
Gravity wilJ empty tank contents into container.
c.
When first tank is empty, repeat step (b) for
other tank, using a different container.
d.
Reconnect hose to chemical inject fitting on
pump. Add 0.5 quart of clean fresh water to
each tank and close tanks covers.
2.
Flush chemical system by selecting one tank,
turning its chemicaJ shut-off vaJve to "On" position
and run pressure washer with black spray tip.
Flush untiJ first tank is empty. Turn its chemicaJ
shut-off vaJve to "Off" position. Flush other tank
the same way.
3.
Shut off engine and Jet it cool, then remove high
pressure and garden hoses. Disconnect spark
plug wire from spark plug.
4.
Empty pump of aJJpumped liquids by puJJing recoiJ
handle about 6 times. This should remove most
liquid in pump.
5.
Use pump saver, avaiJable at Sears retail item
71-74403, to treat pump. This minimizes freeze
damage and lubricates pistons and seals.
6.
If pump saver is not avaiJabJe, connect a 3-foot
section of garden hose to water inlet adapter. Pour
RV-antifreeze
(antifreeze without alcohol) into
hose. PulJ recoiJ handJe twice. Disconnect 3-foot
hose.
19
Tabla de contenido
