Rewind Starter; Description Of Pole Hedge Trimmer Main Parts; Mounting And Adjusting - IKRA BHL 3040 Instrucciones De Manejo

spark plug boot (1) of the proper size. (Note: If
terminal has detachable SAE adapter nut, it must
be attached (2) snugly onto spark plug terminal.
A loose connection between spark plug boot and
ignition wire connector in the boot may create arc-
ing that could ignite combustible fumes and cause
a fire.

Rewind Starter

To help prolong the wear life of the starter rope, ob-
serve the following points:
• Pull the starter rope only in the direction specified.
• Do not pull the rope over the edge of the guide bushing.
• Do not pull out the rope more than specified since it
might break.
• Do not let the starter grip snap back, guide it slowly
into the housing. See also chapter "Starting / Stopping
the Engine"!
Replace a damaged starter rope in good time or have
it replaced by your Sunray dealer!
3. Description of Pole Hedge Trimmer
Main Parts
1 Cutting blades
2 Blade scabbard
3 Blade drive gear
4 Adjusting lever
5 Safety handle
6 Adjusting handle
7 Drive tube
Definitions
1 Cutting Blades
Steel blades for cutting hedges and shrubs.
2 Blade Scabbard
Covers and protects cutting blades when hedge cut-
ter is not in use.
3 Blade Drive Gear
Converts rotary movement of angle drive into recipro-
cating movement.
4 Adjusting Lever
Used to set cutter bar to the required angle.
5 Safety handle
Device use to protect adjusting blade angle.
6 Adjusting handle
Device use to adjusting the blade angle.
7 Drive Tube (Boom)
Encloses and protects the drive shaft between the
coupling sleeve and gearbox.

Mounting and adjusting

Mounting
The hedge trimmer head (1) and shaft part (2) are sepa-
rate in the carrton, you must mount them together before
use.
Step 1
Unscrew the bolt (1) from the hedge trimmer head.
Step 2
Insert the shaft to the hole (1) of the hedge trimmer head.
You can runing the shaft until the hole (2) of the shaft is
show from the hole (3).
Step 3
Screw down bolt 1 and 2.
GB-11