Operation - Ryobi RY64400 Manual Del Operador

WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
INSTALLING THE FRONT HANDLE
See Figure 2.
 Position the front handle as shown with label facing up.
 Depress the buttons on the handle and insert into the
frame. Press down on the handle until the button on the
handle clicks into place
INSTALLING THE HANDLEBAR
See Figure 3.
 Locate handlebar knobs and bolts.
 Position upper handlebar onto lower handlebar. Make
sure the throttle cable and throttle trigger is on the right
side as shown.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
ASSEMBLY
NOTE: Do not allow throttle cable to become pinched
when installing the handlebar.
 Align the holes in the clip, the upper handlebar and lower
handlebar.
 Install bolt as shown in Figure 3.
 Thread handlebar knob onto bolt and tighten securely.
Repeat with other side
INSTALLING THE WHEEL/DRAG BAR
ASSEMBLY
See Figures 4 - 5.
Use the wheel/drag bar assembly to transport the unit to
and from the work area.
To install:
 Locate the Wheel/Drag Bar Adjustment Knob
NOTE: For installation with the Drag bar up, see
Figure 4; for installation with the Drag bar down, see
Figure 5.
 Insert the wheel/drag bar assembly support rod, with
drag bar pointed upward, into the opening beneath the
adjustment knob. To place the wheels in a high position,
insert the rod to the first hole. For a lower wheel position,
insert the rod to the second or third hole.
 Insert wheel/drag bar adjustment knob. Rotate clockwise
to secure the wheel assembly in place.

OPERATION

WARNING:
Do not allow hands, feet, or any other part of the body
or clothing near the rotating tines or any other moving
part. The tines begin to rotate forward once the engine
is started and the throttle trigger is depressed. The tines
continue to rotate until the throttle trigger is released. Fail-
ure to avoid contact could cause serious personal injury.
CAUTION:
Attempting to start the engine before it has been properly
filled with lubricant will result in equipment failure.
ADDING/CHECKING ENGINE LUBRICANT
See Figure 6.
Engine lubricant has a major influence on engine
performance and service life. This unit is shipped with a
20W50 engine lubricant to assist in the break-in period.
For best operating performance, continuing to use 20W50
engine lubricant is recommended, however, SAE 30, 10W30,
or 10W40 are all acceptable lubricants to use in this product.
7 - English