Cleaning And Maintenance - Topcom KS-4216 Manual De Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
USE
Connect both the parent unit and the baby unit to the provided
power adaptors or battery. Press the Power button . The power
LED will light up in green. Put the baby unit in the baby room and
putat 2m distance from the baby. Parents can hear the baby's
voice with the receiver. If the parent unit volume is too low, adjust
the volume. The volume LEDs indicate the sound level of the
baby.
Pairing
Under the normal conditions, the units are correctly paired by the
manufacturer. But in some cases it is necessary to pair the unit
again. You will have to do that if the parent unit (receiver) loses
the signal from the baby unit (transmitter).
First, turn on both baby and parent units.
Now press the pairing button at the side of both baby and parent
units simultaneously. After this, release the pairing button.
Battery Power
For both units, receiver and transmitter, use exclusively AAA size
1.5V alkaline batteries (6 pcs required, but not included).
Unscrew the screw of the battery compartment, take the lid off
and insert the batteries with the right polarity. Put the lid back,
screw in the screw and check that it is perfectly closed. Switch
the unit on and check that the power LED is on and in green.
Mains power
The Baby monitor can operate by batteries as well as by power
adaptors. Insert the power adaptor into an AC outlet. If your outlet
has a security switch, make sure it is on. Switch the unit on and
check that the power LED is on and in green.
When the battery becomes weak, the power LEDs of the units
turns red. Replace the batteries as soon as possible. For
extended use, it is advised to use a power adapter.
If the receiver is too far from transmitter, they won't work properly.
You will hear a beeping sound which is the out of range alert. The
volume LEDs will flash as well. In this case, you have to put the
two units nearer to each other. If the receiver is too close to the
transmitter, an acoustic feedback might be heard. In this case,
you have to put the two units farther away from each other, or
turn down the volume of the receiver.
A background noise from the receiver may indicate that the
batteries are running and they need to be replaced. Check if the
power LED is turning orange, this indicates that the batteries
need to be replaced.
If there is no sound in the baby unit's vicinity, the baby unit will
stop transmitting the signal to the parent unit. The parent unit is in
VOX mode (standby mode). When there is sound again from the
baby unit, it will trigger the parent unit to work again.
If you have a poor signal, please make sure the baby & parent
units are not out of range. In extreme cases, you can try to re-pair
the units.

CLEANING AND MAINTENANCE

Clean the appliance with a damp cloth. Never use harsh and
abrasive cleaners, scouring pad or steel wool, which damages
the device.
Never immerse the electrical device in water or any other liquid.
The device is not dishwasher proof.
Instruction manual
EN
5
Tabla de contenido
loading

Tabla de contenido