Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Note – Input
• Hold the UP button (4) and the DOWN button (5) to select the values faster.
• A selected item will flash to indicate that it can be set.
Note
• The day of the week is automatically selected when you set the date manually.
• The settings will automatically close if there is no entry for 20 seconds. The
settings that were made up to that point are not saved!
5.2Setting and using the alarm function
• In normal time mode, press the MODE button (2) once to set the alarm
function. ALM is shown on the display.
• Press the SET button (3) for approximately 2 seconds. The hours display
begins to flash.
• Press the UP button (4) or the DOWN button (5) to select the hour for the
alarm time and confirm your selection by pressing the SET button (3). The
minutes display begins to flash.
• Repeat the process to set the minutes for the alarm time. Then confirm the
process with the MODE button.
• Press the MODE button (2) twice to go to the start display.
• To activate the alarm function, you must press the MODE button (2) once to
switch to ALM mode. If you press the UP button (4) once, the bell symbol
appears on the display and the alarm is set.
• If you press the DOWN button (5) during the alarm, the alarm will be
interrupted for 4 minutes and then go off again. The (
flashes.
• If no button is pressed, the alarm automatically switches to the snooze
function; the alarm will be likewise interrupted for 4 minutes and then go off
again. The (
• Press any button (except the DOWN button) to stop the alarm/snooze
function.
Note
• When the alarm function is activated, the alarm melody sounds daily at the
selected time.
• To completely deactivate the alarm function, press the MODE button (2) and
then press the UP button (4) three times until the
shown on the display. Press the MODE button (2) twice to return to the start
display.
4
:
and
) symbol flashes.
is no longer shown on the display.
:
and
) symbol
symbol is no longer
Tabla de contenido
