Carrera RC Thunder Storm Instrucciones De Montaje página 12

Frequency bind between
model and remote control
1
ON
ON
• Connect the plug-in connection at the model and switch on the model at the ON/OFF
switch.
• The LED in the helicopter now flashes in rhythmically-accelerating sequence.
• Switch on the controller at the ON/OFF switch.
While connecting, the controller emits a signal tone.
• Place the charged helicopter on a flat surface.
• Allow the helicopter a few moments until the system is correctly initialised and is
ready for operation.
• The control LED now lights continuously once again, indicating that the connection
is ended.
Range of functions of the remote control
1
4
2
7
8
8
9
The Carrera RC helicopter and the
remote control are frequency bound at
purchase. Should there occur any prob-
lems with the communication between
the Carrera RC helicopter and the
remote control at the beginning, please
carry out a new frequency bind.
1
3
2
5
6
1. Antenna
2. Power switch (ON / OFF)
3. Control LED
4. Gas
5. Forward/backward
Tail (rotation)
6. Trimmer for tail
7. Battery compartment
8. Slot for keeping
Joystick extensions
9. Joystick extensions
to screw on lever 4. & 5.
Description of helicopter
1
1. Coaxial rotor system
2. Tail rotor
3. Plugged connection for charging the lipo battery.
4. Landing skids
5. ON-/OFF switch
Controlling the helicopter
In case you don´t know the control functions of your Carrera RC helicopter yet,
please take some minutes before the first flight in or to make yourself familiar
with them. The descriptions left or right refer to the view out of the cockpit
(pilote´s view).
1
2
+
‒
3
r
l
4
l r
12
1
5
3
4
Push the throttle up to increase the rota-
tional speed of the main rotor blades.
Increase the rotational speed of the
main rotor blades and the model will
+
start to ascend.
If you push down the throttle and thus
‒
reduce the rotational speed of the main
rotor blades the helicopter will descend.
When the model has lifted off the
ground you can get it into stationary
hovering without abrupt ascending or
descending by carefully moving the
throttle upwards and downwards.
Move the right lever (tail) to the left and
the helicopter's nose turns (yaws) round
the main rotor's axis in a circle to the
left.
Move the right lever (tail) to the left and
the helicopter's nose turns (yaws) round
the main rotor's axis in a circle to the
left.
Use the trimmer for tail until you have
reached a stable neutral position of the
helicopter when hovering, without
moving the right lever (tail).
2