Mounting The Pin - Ottobock 6A40 Magno Flex Lock Instrucciones De Uso

► Do not use liquid thread lock (e.g. Loctite®). The thread lock damages
the plastic material.
INFORMATION
The product contains a magnet
► Maintain a safety distance of at least 12 cm from a pacemaker.
Required tools and materials:
>
Socket adapter, 501S41=M6X45 flat head screws, 506G3=M3X5-"Niro"
set screw, 710D4 torque wrench, torque wrench (adjustable to 0.5 Nm)
1) Align the shuttle lock such that the magnet is aligned proximally and the
ratchet unit medially or laterally.
2) Set the shuttle lock on to the prosthetic socket (see fig. 14).
3) Optional: Position the 4X314 spacer plate and then the 6A41 slide plate
on the shuttle lock.
4) Position the chosen socket adapter on the shuttle lock.
5) Select the flat head screws for the socket adapter:
For 4R54: 501S41=M6x45
For 4R77: 501S41=M6x50
6) Insert the flat head screws through the socket adapter and the shuttle
lock into the lamination adapter and tighten them (see fig. 15) (tightening
torque: 12 Nm).
7) Screw the ratchet unit (see fig. 16, item 1) into the shuttle lock and tight­
en with the torque wrench (tightening torque: 10 Nm).
8) Secure the ratchet unit with the set screw (see fig. 16, item 2) (tighten­
ing torque: 0.5 Nm).

5.3 Mounting the pin

CAUTION
Installation of the pin in a liner that is not approved
Risk of injury due to loosening of the screw connection
► Only install the pin in liners with a metal thread and observe the spe­
cified tightening torque.
The pin to connect the liner to the shuttle lock is screwed into the thread at
the distal end of the liner.
Required tools and materials:
>
Torque Wrench (adjustable to 3 Nm), 636K13 Loctite
1) Apply Loctite
®
to the thread.
®
23