Troubleshooting - Pulsar N450 Manual De Usuario

29

Troubleshooting

Listed below are some potential problems that may occur when using the scope.
Carry out the recommended checks and troubleshooting steps in the order
listed. Please note that the table does not list all of the possible problems. If the
problem experienced with the scope is not listed, or if the suggested action meant
to correct it does not resolve the problem, please contact your seller.
PROBLEM
The riflescope will not turn on. The Battery Pack is
The riflescope will not operate
on external power supply.
The reticle is blurred and
cannot be focused with the
dioptre knob.
The image is too dark.
With a crisp image of the
reticle, the image of the
observed target that is at least
30 m away is blurred.
The aiming point shifts after
firing rounds.
The riflescope will not focus.
POSSIBLE CAUSE
empty.
USB cable is damaged.
External power supply
is discharged.
The diopter adjustment
range is not enough for
your eyesight.
Condensation on the
external surface of the
eyepiece lens.
Brightness or contrast
level is too low.
Dust and condensate
are covering the
outside optical surfaces
after the riflescope
was brought in from
the cold into a warm
environment, for
example.
The riflescope is not
mounted securely or
the mount was not fixed
with thread sealant.
Wrong settings.
The riflescope is used
in the daytime at long
distances.
СORRECTIVE ACTION
Charge the Battery Pack.
Replace USB cable.
Charge the external power supply (if
necessary).
If you wear prescription glasses
with a range of +/-5, keep glasses on
when looking through the eyepiece.
Clean the lens with a cloth.
Adjust brightness/contrast level.
Clean the lens surfaces with a
blower and soft lens cloth. Let the
riflescope dry by leaving it in a warm
environment for 4 hours.
Check that the riflescope has been
securely mounted, make sure that
the same type and calibre bullets are
being used as when the scope was
initially zeroed; if your riflescope was
zeroed during the summer, and is
now being used in the winter (or the
other way round), a slight shift of the
aiming point is possible.
Adjust the riflescope according to the
instructions given in the Section 9
"OPERATION" and check the surfaces
of the eyepiece and objective lenses
and clean them if necessary from
dust, condensation, frost, etc; to
prevent fogging in cold weather,
apply a special anti-fog solution.
Check focusing in the nighttime.
27