Pulsar N450 Manual De Usuario página 13

12 Zeroing
The riflescope features two zeroing methods - "one shot" zeroing and using
FREEZE function. Zeroing should be done at operating temperatures, by following
the order of these steps:
•
Mount the rifle with the riflescope installed on a bench rest.
•
Set a target at a certain distance.
•
Adjust the riflescope according to the instructions of section 9 "Powering on
and image setup".
•
Select the zeroing profile (see main menu option «Zeroing profile»
•
Aim the firearm at the target and take a shot.
•
If the point of impact does not match the aiming point (centre of the riflescope's
reticle), hold down the M (9) button to enter the main menu.
•
Enter the submenu "Zeroing"
to confirm.
•
Set the zeroing distance value (see main menu option "Zeroing" => submenu
"Add new distance"
•
Go to the submenu with a brief press of the M button.
•
Select icon
confirm.
•
Additional menu for zeroing parameters setup appears on the
display.
•
An auxiliary cross
coordinates of the auxiliary cross X and Y appear in the top right
corner (Pic. 5).
•
Select icon with UP/DOWN buttons. Press the M button to
confirm.
•
Holding the reticle in the aiming point, with UP/DOWN buttons to
move the auxiliary cross horizontally or vertically relative to the
reticle until the auxiliary cross matches the point of impact.
Attention! Not to hold the reticle in the aiming point, you can use
the FREEZE function – freezing
the zeroing screen (refer to main
menu option "Zeroing" => submenu
"Distance" => submenu "Zeroing
parameters setup" => submenu
FREEZE .
•
Switch between movement
directions of the auxiliary cross
from horizontal to vertical with a
brief press of the M button.
•
Save the new position of the
reticle with a long press of the
M button.
•
Message "zeroing coordinates saved" confirms successful operation.
•
Menu exit takes place. The reticle will now move to the point of impact.
•
Exit the submenu, take another shot - the point of impact should now match
the aiming point.
).
with UP/DOWN buttons. Press the M button to
appears in the centre of display, and
with UP/DOWN buttons. Press the M (9) button
Windage
)
11