Pulsar N450 Manual De Usuario página 12

Powering on and image setup
•
Open the lens cover (12).
•
Turn the riflescope on with a brief press of the ON (5) button. Image appears on
the display in several seconds.
•
To turn off the display during operation, press and hold down the ON button
longer than one second.
•
Turned off display will show a message "Display off".
•
To turn on the display, press briefly the ON button.
•
To turn off the riflescope, press and hold down the ON button longer than three
seconds. Display will show a message "Display off" and a countdown from 3 to 1
sec, and will turn off upon countdown expiration.
•
Rotate the dioptre adjustment ring (2) to see a crisp image of the aiming reticle
and the status bar icons. Once this adjustment is done, there is no need to
rotate the dioptre adjustment ring for distance or any other conditions.
•
Point the riflescope at an object located at a certain distance (20-30 m for
example).
•
Rotate the lens focus knob (7) to see a crisp image of the object observed.
•
To set up display brightness and contrast, digital zoom, please refer to the
QUICK MENU FUNCTIONS section.
•
To improve image quality in low light conditions or in complete darkness, turn
on the built-in IR Illuminator (4). Please refer to section 10 to read about IR
Illuminator operation.
•
After use, hold down the ON button to turn the unit off.
11 Built-in IR Illuminator
The riflescope is equipped with a built-in IR Illuminator featuring a wavelength
of 940 nm or 850nm which provides significant increase in observation range in
lowlight conditions and in the darkness.
•
Make sure that the IR Illuminator is mounted and connected to the riflescope –
the display will show icon of the connected or disconnected IR Illuminator.
•
To activate the IR Illuminator: turn on the riflescope with the ON (5) button,
press briefly the IR button (19) on the edge of the IR Illuminator. IR power level
upon start is minimal
•
IR Illuminator icon with respective power level is shown in the bar status.
•
To switch between power levels press briefly the IR button (
To deactivate the IR Illuminator, hold down the IR button.
Removing the IR Illuminator:
•
To remove the IR Illuminator, raise the lever (18) and pull. Install the plug (16).
•
The status bar will show an icon of the disconnected IR Illuminator (
Notes:
•
Upon turning the IR off, power level is not saved in the riflescope's memory.
•
IR Illuminator is not focusable.
•
IR Illuminator's heat sink becomes hot: this is normal and is not a defect.
10
.
).
).