Changing The Output Level; Additional Information; Precautions; Notes On Compact Discs - Sony CDX-535RF Manual De Instrucciones

Changing the output level

You can select the output level from the unit.
Normally the unit is used in the initial output
level; change the level if necessary.
1
Press (SHUF/REP) for two seconds.
2
Press (SHUF/REP) momentarily.
3
Press or
select the output level.
To decrease the output level
: ,
To increase the output level
:
,
4
Press (SHUF/REP) for two seconds.
Using on the wireless remote
1
Press (SHUF) for two seconds.
2
Press (SHUF) again momentarily.
3
Press or
output level.
4
Press (SHUF) for two seconds.
Note
When you select level 4 or 5, the CD playback
sound may be distorted or you may hear some
noise. In such a case, select a lower output level on
the unit and turn down the overall volume on your
car audio.

Precautions

• This unit cannot be used with a car audio
• If your car was parked in direct sunlight
Initial setting
repeatedly to • If no power is being supplied to the unit,
• Avoid installing the CD changer, wireless
If you have any questions or problems
concerning your unit that are not covered in
this manual, please consult your nearest Sony
dealer.

Notes on compact discs

to select the
A dirty or defective disc may cause sound
drop-outs during CD playback. To enjoy
optimum sound, handle the disc as follows.
Handle the disc by its edge, and do not touch
the unlabelled surface.
Do not stick paper or tape on the discs.
Additional
Information
without FM tuner.
resulting in a considerable rise in
temperature inside the car, allow the unit to
cool off before operating it.
check the connections first. If everything is in
order, check the fuse.
remote, and wired remote in places:
— subject to temperature exceeding 55°C.
— subject to direct sunlight.
— near heat sources (such as heaters).
— exposed to rain or moisture.
— exposed to excessive dust or dirt.
— subject to excessive vibration.
This way
Not this way
9