Creating An Optical Sonet/Sdh/Otn Multi-Channel Sdt Test Case - EXFO FTB-8510B Guia Del Usuario

Creating an Optical SONET/SDH/OTN Multi-Channel
SDT Test Case (FTB-8120/8130/8140)
The following procedure describes an optical SONET/SDH/OTN
Multi-Channel test case on the FTB-8120, FTB-8120NG, FTB-8120NGE,
FTB-8130, FTB-8130NG, FTB-8130NGE, and FTB-8140 modules.
To create an Optical SONET/SDH/OTN Multi-Channel Test:
1. Test configuration:
1a. Select Multi-Channel SDT as the Test Mode.
1b. Press Next.
1c. The Optical port is automatically selected.
2. Interface selection:
2a. Press the desired interface: OC-3, OC-12, OC-48, OC-192,
3. Press Finish to complete the test setup. The Grid tab closes and
automatically switches to the SDT - Monitor tab.
4. For additional configuration parameters and results, refer to Summary
Tabs on page 125 and Service Disruption Time (SDT) - Results on
page 421.
5. Press the Start button to start the test. Refer to Global Test Status and
Controls on page 35 for more information on test management.
SONET/SDH Application
Refer to Test Configuration on page 126 for
more information.
Press Next.
OC-768, STM-1, STM-4, STM-16, STM-64, STM-256, OTU1, OTU2,
OTU3. Choices depend on the rates available on the module.
Creating and Starting a Test Case
Typical Test Cases
91