Extracting Dry Materials; Extracting Wet Materials/Liquids - Festool CTL 26 E AC HD Manual De Instrucciones

Possible causes
Monitoring electronics malfunction.
Wet extraction.
7.6 Systainer depot
The surface of the mobile dust extractor doubles up
as a surface for storing Systainers:

Place the Systainer in the Systainer retainer [3a].

A Systainer adapter (accessory) must be attached
to the top section using four screws in order to
obtain a secure connection [3b].
8 Working
8.1 AUTOClean - Cleaning the main filter
Only in conjunction with disposal bag (com-
pliance with dust class 'L/M'). Not suitable for
wet extraction!
Automatic cleaning
Activate using the rotary knob [1-14].
Manual cleaning
Turn the switch [1-12] to the AC symbol.
Full manual cleaning [4]

Cover the end of the nozzle or suction hose with
your hand or closing slide CT-VS (497926).

Turn the switch [1-12] to the AC symbol.
8.2

Extracting dry materials

CAUTION
Hazardous dust
Damage to the respiratory passage

Always use a filter or disposal bag!

Only use when volumetric flow monitoring is
functional (dust class M only).
When extracting large quantities of oak or
beech wood dust or dust that exceeds the per-
mitted limit values, only extract from a single
machine (electric or air tool).
Observe the following when extracting dust generat-
ed by operating electric power tools:
Ensure there is adequate ventilation! Observe re-
gional regulations!
Limit values: exhaust air max. 50% of the clear air
volume
Formula: room volume V x air renewal rate L
R W
Solution
Send to a Festool service workshop for repair.
Functional reliability not affected, no actions required.
8.3

Extracting wet materials/liquids

Remove the filter or disposal bag!
Recommendation: use special wet filter (NF-
CT).
The dust extractor stops automatically when the
maximum level is reached.
After wet extraction, allow the main filter to dry!
Escaping foam and fluids

Switch off and empty the machine immediately.
8.4 After finishing work

Clean the main filter automatically or manually
(see Chapter 8.1).

Switch off the mobile dust extractor and pull out
the mains plug.

Wind up the mains power cable, secure the end of
the cable in the slot [5].

Empty the dirt trap.

Place the mobile dust extractor in a dry room in-
accessible to unauthorised users.

Fold up the hose holder [1-10].

Wind the hose around the bracket on the hose
holder.

Push the end of the hose over the bracket.

Dust class M only: close the intake opening [1-7]
with the sealing plug [1-1] or closing slide [1-
16].
Hazardous dust
Damage to the respiratory passage

Clean the mobile dust extractor and all accesso-
ries thoroughly using the extractor (inside and
out) and wipe down before removing from the
working area (dust class M only).

Parts that you were not able to clean thoroughly
must be sealed in an airtight plastic bag prior to
transportation.

Wear a dust mask.
CTL /M
CAUTION
WARNING
GB
15