Connecting The Electrical Power To Magicspeed - Waeco MagicSpeed MS880 Instrucciones De Montaje

MagicSpeed MS880
7.3 Installing the clutch switch
I
NOTE
Check whether your vehicle features a clutch switch. If it does,
you do not have to install the clutch switch supplied.
Install the clutch switch as follows (fig. 8, page 7):
➤ Fasten the magnet (fig. 8 1, page 7) to the clutch pedal using double-
sided adhesive tape or cable binders.
➤ Fasten the clutch switch (fig. 8 2, page 7) in the footwell using the
screws supplied or double-sided adhesive tape.
➤ Connect the 2-pole clutch switch compact plug (fig. 8 2, page 7) with the
2-pole compact plug on the cruise control cable set.
I
NOTE
On vehicles with manual transmission, you can use the clutch
switch to prevent engine overspeed. The cruise control switches
off automatically when you press down the clutch.
8 Connecting the electrical power to
MagicSpeed
8.1 Laying and connecting the cable set
Please note the following:
 To prevent damage to the cables when laying them, ensure that they are
far enough away from hot or moving vehicle components (exhaust pipes,
drive shafts, light systems, fans, heater etc.).
 Wrap insulating tape around every connection on the cable (even inside
the vehicle).
 When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 3,
page 4).
 Protect every hole you drill against water penetration, e.g. by using a
cable with a sealant and by spraying the cable and the the cable sleeve
with sealant.
EN

Connecting the electrical power to MagicSpeed

55