Connection Options; Safety Features - Waeco MagicSpeed MS880 Instrucciones De Montaje

Technical description
6.2

Connection options

MagicSpeed MS880 can process either a digital speed signal from the CAN
bus (CAN bus connection) or an analogue speed signal (analogue connec-
tion). A CAN bus connection is not possible in all vehicles with a CAN bus.
I
NOTE for vehicles with CAN bus
 You can find out whether a CAN bus connection is possible for
your vehicle from the vehicle-specific product overview on our
homepage, or by calling to enquire (see rear page of the man-
ual for contact data).
 If your vehicle features a CAN bus, but a CAN bus connection
is not possible according to the vehicle list, MagicSpeed
MS880 must be connected using a analogue connector. This
will require the speed signal to be received in analogue form.
If the speed signal is only available on the CAN bus in digital
form, you will require the CAN bus interface MagicSpeed
CBI150 for the installation of MagicSpeed MS880. This con-
verts the digital speed signal from the CAN bus into an ana-
logue one.
 A CAN bus interface is not required for the CAN bus connec-
tion.
6.3

Safety features

A
NOTICE!
If your vehicle has a steering wheel lock, make sure that it is not
activated when the key is in the ignition or a gear is selected.
The cruise control is equipped with numerous safety features to switch it off
if any of the following situations arise:
 The brake is applied hard
 Pressing the clutch pedal
 Pressing the accelerator and brake pedal at the same time (savior func-
tion)
 The ON/OFF button on the control element is pressed
 The engine overspeeds
 Braking to 50 % of the set speed
 Accelerating to 150 % of the set speed
 Increases the engine speed by 150 %
52
MagicSpeed MS880
EN