Setting The Sensitivity; Using Magicspeed - Waeco MagicSpeed MS880 Instrucciones De Montaje

Using MagicSpeed

➤ Switch on the cruise control by pressing the ON/OFF button on the control
element briefly (< 1 sec).
✓ You will hear two low-pitched signals.
✓ The LED on the control element lights up in green.
➤ Drive at a speed of 40 to 50 km/h.
➤ Press the SET button to configure the preferred speed.
✓ The cruise control gently takes on the speed and maintains the driving
speed at a constant level.
14.2

Setting the sensitivity

If the cruise control does not switch on gently and the speed increases or
decreases during control mode, you can adjust the sensitivity of the cruise
control (see page 68):
 If the cruise control works too suddenly or the vehicle speeds up too
much, you must decrease the GAIN value (see "Setting the control sensi-
tivity (GAIN mode)" in the diagnostics manual on our homepage).
 If the cruise control works too slowly or the vehicle slows down too much,
you must increase the GAIN value (see "Setting the control sensitivity
(GAIN mode)" in the diagnostics manual on our homepage).
15 Using MagicSpeed
MagicSpeed is controlled using the buttons on the control lever.
15.1 Using the cruise control
ON/OFF button
➤ Press the ON/OFF button once briefly (< 1 sec) to switch on the cruise
control.
✓ You will hear two low-pitched signals.
✓ The LED on the control element lights up.
➤ Press the ON/OFF button again to switch the cruise control off.
✓ The LED on the control element goes out.
76
MagicSpeed MS880
EN