Connecting Magicspeed Electrically - Waeco MagicSpeed MS800 Instrucciones De Montaje Y De Uso

_MS-800.book Seite 58 Donnerstag, 1. Juni 2006 8:22 08

Connecting MagicSpeed electrically

➤ Temporarily mount the interface module at the selected position.
Do not fasten the interface module before you have decided where to lay
the cables.
➤ After finishing assembly, fasten the module to the selected position:
Screw the interface module securely to the vehicle with the screws
supplied or use double-sided adhesive tape.
6.4 Installing the clutch switch
Install the clutch switch as follows (0, page 8):
➤ Fasten the magnet (0 1, page 8) to the clutch pedal using double-sided
adhesive tape or cable binders.
➤ Fasten the clutch switch (0 2, page 8) in the footwell using the screws
supplied or double-sided adhesive tape.
➤ Connect the two cables of the clutch switch (0 2, page 8) to the brown
cable from the wiring harness of the speed controller by splicing it and
connecting the clutch switch in series to the brake pedal switch (0 3,
page 8).
On cars with manual gearboxes you can use the clutch switch to
prevent engine overspeed. The speed regulator switches off
automatically when you press down the clutch.
7 Connecting MagicSpeed electrically
7.1 General notes on laying cables
As far as possible, use original openings or alternative openings
for the connecting cable duct, e. g. the panelling edges, ventilation
grilles or blank panels. If no openings are available, you must drill
holes for the cables. Check beforehand that there is sufficient
space on the other side for the drill head to come out.
Cables and connections which are not properly installed will
cause malfunctions or damage to components. Correct
installation of cables and connections ensures lasting and trouble-
free operation of the retrofitted components.
58
MagicSpeed MS800