Sears 61011 Manual De Uso página 44

Questions? Before You Call for Service...
PROBLEM
TOP BURNERS DO NOT
LIGHT OR DO NOT
BURN EVENLY
BURNER FLAMES VERY
LARGE OR YELLOW
SURFACE BURNERS
LIGHT BUT OVEN
DOES NOT
POSSIBLE CAUSE
• Malce sure electrical ptug is plugged into a live power oudeto
• Burner holes on the side or around the top of burner may be clogged,
Remove burners (on models with standard twin burners) or burner heads
(on models with sealed burners) or burner caps on spill-proof models, and
clean them with a sewing needle or twist tie. Make sure you do not enlarge
the holes° On spill-proof models, check electrode area for burned-on food or grease.
• Pilot(s) is (are) not lit (on standing pilot models). See the Lighting
Instructions for Standing Pilot Models section in Surface Cooldng.
• If range is connected to I.P gas, check all steps in the Installation Instructions.
The oven gas shut-offvalve may have accidentally been moved during
cleaning or moving.
To check the oven gas shut-offvalve on standard twin burner models, raise
the cooktop und look for the gas shut-off lever at the extreme right rear
corner. (Standing pilot models do not have a gas shut-offvalve on the reg_ator.)
Follow the directions in box A or B that match your regulator type.
_OWn
xPULL TO OPEN
;tandard Twin Burner Models
Lever shown ctosed /
Standard Twin Burner Models
To check the oven gas shut-off valve on sealed burner models, remove
the storage drawer, broiler drawer or kick panel and look for the gas shut-
off lever at the back of the range.
Fo!low the directions in box A or B that match your regulator type.
A
_c!osed. PULL/
Sealed Burner Models Sealed Burner Models
44