Initial Use; Operation - Beurer MG 520 To Go Instrucciones De Uso

6. Initial use

• Remove the packaging.
• Check the device, mains part and cable for damage.
• Insert the connector plug into the socket on the massager to charge the device.
• Charge the device for at least 3 hours before initial operation. The on/off LED flashes blue on the control
panel during charging.
As soon as the device is fully charged, the LED light lights up blue.
When the battery is flat, the LED light flashes red.
The device can also be used during charging. However, this makes charging slower.
• Ensure that the cable does not pose a trip hazard.

7. Operation

At first, just press the body area that you want to massage carefully against the massager. Then check
carefully whether the massage position is pleasant for you and then lower your weight gradually towards the
massager. Set the distance between the massage heads using the dial [7]. To do this push the dial downwards
to disengage the lock and turn the dial left or right at the same time.
The massage should feel pleasant and relaxing at all times. If the massage is painful or uncomfortable, stop
the massage or change your position or the contact pressure.
• Do not force or jam any part of your body, in particular your feet, hands and fingers, between the rotating
massage heads or their holders in the device.
• Switch on the massager using the
button again to change the massage direction. Pressing the button again turns the device off. Press
the button to activate the light and heat function. Press the
heat function.
Note
• The cushion can be attached to a chair using clip buckles.
• You can also use the cushion using the handles.
• Use the massager for max. 15 minutes. Longer massages can lead to over-stimulation of the mus-
cles, creating tension instead of aiding relaxation.
Back massage: upper back
area
button. The massage heads start to rotate. Press the
Back massage: lower back
area (lumbar)
button again to turn off the light and
Leg massage
15
Back massage: upper
back area