5. DEVICE DESCRIPTION
The associated drawings are shown on page 3.
Massage heads
1
Connection socket
2
Heat button
3
Intensity button
4
6. USAGE
6.1 Initial use/preparing for use
1. Remove the packaging. Check the device, mains adapter and cable for damage.
2. Connect the mains adapter
the other end of the mains adapter into a suitable socket.
3. Ensure that the cable does not pose a trip hazard.
6.2 Using the device on your feet
CAUTION
Do not force or jam any part of your body, in particular your fingers, between the rotating massage heads
or their holders in the device.
Use the device for a maximum of 15 minutes. Longer massages can lead to over-stimulation of the
muscles, creating tension instead of aiding relaxation.
Massaging a specific point on the sole of the foot can influence the corresponding organs of the
body. However, we recommend studying relevant literature and asking your doctor before using
point reflex zone massage to achieve the desired effect for you.
1. Place the device on a firm, level surface.
2. Remove your shoes before each use. Sit in a comfortable position.
3. If you wish, you can place the hygienic cover
the device barefoot).
4. Place your feet on the massage heads
from slipping.
5. Press the ON/OFF button
The ON/OFF button
the beginning, the device intensity is always preset to low (green) and the heat function is always de-
activated. Further information on the individual settings options can be found in chapter "6.4 Settings
options".
6. The massage should feel pleasant and relaxing at all times. If the massage is painful or uncomfortable,
stop the massage or change your position or the contact pressure.
The device has an automatic switch-off function. It switches off automatically after 15 minutes
of operation.
7. To end the application manually, press the ON/OFF button
The ON/OFF button
to the connection socket
8
(see figure
1
to switch on the device.
6
will start to light up green and the massage heads
6
will go out and the massage heads
6
Mode button
5
ON/OFF button
6
Hygienic cover
7
Mains adapter
8
on the side of the device (see figure
2
over the device for hygiene reasons (e.g. when using
7
). Rubber feet on the base of the device stop it
B
again.
6
will stop.
1
15
A
will begin to rotate. At
1
). Plug
1