Echo DSRM-300 Manual De Instrucciones página 16

Operation
 All over head electrical conductors and communications wires can have electricity flow with high voltages. This unit
is not insulated against electrical current. Never touch wires directly or indirectly, otherwise serious injury or death
may result.
 Always stop the unit when a cutting attachment jam occurs.
Severe injury can occur if a jam is removed and the cutting attachment suddenly starts.
 Do not operate the product without the shield in place.
Any objects that ricochet off the cutting attachment could cause an accident or serious injury.
 The area within a 15 m radius of the product is a danger zone. Be care-
ful to observe the following precautions while working with the prod-
uct.
 Do not allow children and other people or pets to enter the danger
zone.
 If another person enters the danger zone, switch off the unit to stop
the cutting attachment from rotating.
 When approaching the operator, signal to him by, for example,
throwing twigs from outside the danger zone, and then check that
unit has been switched off and the cutting attachment has stopped
turning.
 If more than one person is working with the product, identify the way
in which you will signal to each other and work at least 15 m apart.
Any objects that ricochet off the cutting attachment, and any contact with the cutting attachment, could cause blindness or a
fatal accident.
Be particularly careful to observe the following precautions when starting the unit:
 Check that none of the nuts and bolts are loose.
 Leave plenty of space around the product and do not allow people or animals near it.
Failure to observe the precautions could cause an accident or injury, or even lead to a fatality.
 Check that there are no abnormal vibrations or sounds once the unit starts. Do not use the product if there are ab-
normal vibrations or sounds. Contact your dealer to have it repaired.
Accidents involving parts that fall or shatter off can cause wounds or serious injury.
 Always switch off the unit and remove the battery when transporting the unit.
 Do not touch angle transmission and other high temperature components while the product is running
or for some time after it stops.
You could burn yourself if you touch a high temperature component.
 Before starting work, check the area where you will be working and remove any small stones
and empty cans likely to ricochet off the cutting attachment, as well as any pieces of string
or wire that might become twisted around the cutting attachment.
An accident or serious injury can occur if foreign objects ricochet off the cutting attachment or wire
and other materials twisted round the product spring off it.
 In the following situations, switch off the unit immediately and ensure that the cutting attachments have stopped be-
fore checking each area of the product. Replace any damaged parts.
 If the cutting attachment hits a rock, tree, post, or other such obstruction while you work.
 If the product suddenly starts to vibrate abnormally.
Continuing to use parts when they are damaged could lead to an accident or serious injury.
 Do not hold the cutting attachment up while you work. You must not work with the cutting attachments raised above
knee level.
Raising the cutting attachment above knee level brings the plane of rotation closer to the face, and any objects that fly off the
cutting attachments could cause an accident or serious injury.
Operation
DANGER
WARNING
14