DeWalt DCGG571 Manual De Instrucciones página 16

5. Release the grease tube rod (M) from the retaining slot (O) and
slowly press it back into the tube.
6. Use the purge valve (X) to bleed off any air that may be trapped
in the cartridge. Refer to Purging Air Pockets.
FILLING THE TOOL FROM THE LOW PRESSURE FILLER
PUMP (FIG. 2, 5, CON9)
1. Pull back on the grease tube handle slowly and rotate the rod until
it is secure in place.
NOTE: Do not lock the rod into the retaining slot (O).
2. Connect the low pressure fitting on the grease gun to the
appropriate low pressure fitting on the filler pump. These fittings
DO NOT lock together. This prevents the grease gun cartridge
from being over filled.
3. Fill until the rod is pushed out of the grease tube approximately
8" (20 cm). Do not overfill. If the rod fails to move during the filling
process, stop. This indicates that the rod is not connected to the
plunger and step one must be repeated before proceeding.
4. Rotate rod to release and carefully push rod back into the grease
tube.
5. Use the purge valve (X) to bleed off any air that may be trapped
in the cartridge. Refer to Purging Air Pockets.
Purging Air Pockets (Fig. 2, 5)
IMPORTANT: Air pockets in the grease can cause the grease gun to
lose prime. Eliminate air pockets after each refill or if the grease gun
fails to pump grease:
1. Unscrew the purge valve (X) without removing it, until all air has
escaped.
2. Tighten the purge valve (X).
3. Uncap the flexible hose (G) then depress the variable speed
trigger switch (A) for 10–20 seconds.
4. If grease fails to flow through the hose, repeat from step 1.
NOTE: This tool has been tested at the factory, which may result in
a small amount of grease left in the grease tube and hose assembly.
It is recommended to purge the tool with the brand of grease to be
used before first use.
OPERATION
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 10)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (P) into the tool handle, align the battery
pack with the rails inside the tool's handle and slide it into the handle
until the battery pack is firmly seated in the tool and ensure that it
does not disengage.
To remove the battery pack from the tool, press the release button (Q)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
FIG. 10
P
FUEL GAUGE BATTERY PACKS (FIG. 11)
Some D WALT battery packs include a fuel gauge which consists of
e
three green LED lights that indicate the level of charge remaining in
the battery pack.
14
Q