Setup; Folding; Dismantling, Storage And Transport; Dismantling - zarges Z600 Instrucciones De Montaje

5.3 Setup

The setup instructions are in the form of diagrams.

5.4 Folding

The folding instructions are in the form of diagrams.
6.

Dismantling, storage and transport

6.1 Dismantling

> If necessary, use lifting tackle to lay the product on its side.
> Do not lift the product by the guardrails or braces.
> Attach lifting tackle to the body of the access steps or the platform.

6.2 Storage

> Store components in a location where they are protected from the elements,

6.3 Transport

> Fold the product and pack it for transport.
> Use straps to secure components against sliding or falling during transport.
> Do not throw components during loading or unloading.
> Look out for collision hazards (e.g. persons, doors).
7.

Servicing

7.1 Cleaning

> Clean the product with a solution of water and a standard cleaning agent.
> Dry standing surfaces and holding devices thoroughly after cleaning to eliminate

7.2 Inspection

• The product must be regularly inspected by a technical expert to ensure that it is safe
• The inspection intervals must be appropriate for the specific operating
• The inspection must be documented. Check sheets for inspection of the product are
See illustrations section of this manual
See illustrations section of this manual
and if possible, store them laid flat.
slip hazards.
to operate. The technical expert is authorised to carry out inspection by the operator
and must have taken part in the seminars prescribed by law in the country concerned.
conditions. Inspection must be carried out at least once a year.
available on the ZARGES homepage. Following successful inspection, the ZARGES
inspection plate (Order No. 828384 or 828385) must be attached to the product.
The month and year in which the next inspection is due must be clearly visible.
19