Makita 9564P Manual De Instrucciones página 6

For tool with clamp lever type wheel guard
1
2
008375
1
008376
Pull the lever in the direction of the arrow after
loosening the screw. Mount the wheel guard with the
protrusion on the wheel guard band aligned with the
notch on the bearing box. Then rotate the wheel guard
around 180°. Fasten it with the screw after pulling lever
in the direction of the arrow for the working purpose.
The setting angle of the wheel guard can be adjusted
with the lever.
To remove wheel
procedure in reverse.
Installing or removing depressed center
grinding wheel / multi disc (Optional
accessory)
WARNING:
When using a depressed center wheel or multi
•
disc, the wheel guard must be fitted on the tool so
that the closed side of the guard always points
toward the operator.
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
1
2
3
008377
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
1. Wheel guard
2. Bearing box
3
3. Screw
4. Lever
4
1. Screw
guard, follow the
1. Lock nut
2. Depressed
center grinding
wheel/Multi-disc
3. Inner flange
and securely tighten clockwise. To remove the wheel,
follow the installation procedure in reverse.
2
008378
Installing or removing flex wheel (optional
accessory)
1
2
3
4
008382
WARNING:
Always use supplied guard when flex wheel is on
•
tool. Wheel can scatter during use and guard
helps to reduce chances of personal injury.
Follow instructions for depressed center grinding
installation
wheel/Multi-disc but also use plastic pad over wheel.
See order of assembly on accessories page in this
manual.
Installing or removing abrasive disc (optional
accessory)
008383
NOTE:
Use sander accessories specified in this manual.
•
These must be purchased separately.
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
6
1
1
2
3
1. Lock nut wrench
2. Shaft lock
1. Lock nut
2. Flex wheel
3. Plastic pad
4. Inner flange
1. Lock nut
2. Abrasive disc
3. Rubber pad