Functional Description - Makita 9564P Manual De Instrucciones

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Shaft lock
1
008370
CAUTION:
Never actuate the shaft lock when the spindle is
•
moving. The tool may be damaged.
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Switch action
1
008371
CAUTION:
Before plugging in the tool, always check to see
•
that the switch lever actuates properly and returns
to the "OFF" position when released.
Do not pull the switch lever forcibly without pulling
•
in the lock-off lever. This may cause switch
breakage.
To prevent the switch lever from accidentally pulled, a
lock-off lever is provided. To start the tool, pull the lock-
off lever toward the operator and then pull the switch
lever. Release the switch lever to stop.
1. Shaft lock
1. Lock-off lever
2. Switch lever
2
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing side grip (handle)
008373
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
WARNING:
When using a depressed center wheel, multi disc,
•
flex wheel or wire wheel brush, the wheel guard
must be fitted on the tool so that the closed side of
the guard always points toward the operator.
When using an abrasive cut-off / diamond wheel,
•
be sure to use only the special wheel guard
designed for use with cut-off wheels.
For tool with locking screw type wheel guard
1
2
008374
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees
counterclockwise. Be sure to tighten the screw securely.
To remove wheel
procedure in reverse.
5
1. Wheel guard
2. Bearing box
3. Screw
3
guard, follow the installation