Tabla de contenido
DIP Switch Setting:
Pelco-D protocol
Baud rate: 2400bps
Press F4 on the controller and select the same protocol as the one on the camera.
6. Camera ID Setup
Set the binary number for the camera ID by changing the DIP switch (0 = OFF, 1 = ON).
Example: Setting the camera ID as 10 (ID = 0 + 2 + 0 + 8 + 0 = 10).
• You can set the camera ID from 0 to 63. Do not use the value 0 as ID.
• The default camera ID is 1.
• If you desire operating the camera with a controller, the camera ID setting and the controller ID must be identical.
When using more than one camera, it is recommended to memorize the camera IDs and their camera locations.
• Camera ID under Pelco-D = camera ID under Pelco-P/Vicanyx -1. Camera ID 2 under Pelco-D = camera ID under
Pelco-P/Vicanyx.
7. Installation
• A qualified technician should install and service this device according to the local regulation.
• Do not leave fingerprints on the lens as they will affect the picture quality. Clean the lens with a soft cloth. Do not
use alcohol or solvents.
• The auto scan range can be adjusted by the controlling software. The dome does not have any limit stop bolts.
Tilt limit is not adjustable; do not try to make any adjustments by hand.
CAMCOLD3
DIP switch
1
2
Pelco-P Protocol
Baud rate: 9600bps
Non-continuous code
3
4
5
6
Camera ID
Pelco-P protocol
Baud rate: 9600bps
continuous code
- 3 -
7
8
Protocol
Vicanyx protocol
VELLEMAN
Tabla de contenido
Solución de problemas
