Stihl HLE 71 Manual De Instrucciones página 30

English
Position and mark the power supply
–
cord so that it cannot be damaged
or stepped on, tripped over or
endanger others.
Starting lockout lever and trigger
–
switch must move freely – the switch
must return to the idle position when
it is released.
Cutting blades securely mounted
–
and in good condition (clean, move
freely, not warped), properly
sharpened and thoroughly sprayed
with STIHL resin solvent (lubricant).
On units with adjustable cutter bar:
–
Make sure the adjuster is properly
engaged in the required position for
starting.
On units with a defined transport
–
position (cutter bar folded against
drive tube): Never operate the unit
in the transport position.
Never attempt to modify the controls
–
or safety devices in any way.
Keep the handles dry and clean –
–
free from oil and dirt – for safe
control of the power tool.
Adjust shoulder strap and handles
–
to suit your height and reach. See
chapter on "Fitting the Harness".
To reduce the risk of accidents, operate
your power tool only if it is in a safe
condition.
If you use a shoulder strap or full
harness: Practice removing and putting
down the machine as you would in an
emergency. To avoid damage, do not
throw the machine to the ground when
practicing.
28
To reduce the risk of electric shock:
Always connect the power tool to a
–
properly installed wall outlet.
Make sure the extension cord used
–
complies with the regulations for the
intended application.
Check that the insulation of the
–
power cord, extension cord, plug
and coupling is in good condition.
Holding and Controlling the Power Tool
Always hold the power tool firmly with
both hands on the handles.
Right hand on control handle, left hand
on loop handle on drive tube, even if you
are left-handed. Wrap fingers and
thumbs firmly around the handles.
Make sure you have firm and secure
footing and hold the power tool so that
the cutting blades are always away from
your body.
Some versions of the machine can be
carried on a harness to relieve the
weight on the operator's arms.
During Operation
In case of imminent danger or in an
emergency, switch off the motor
immediately – release the trigger switch
and starting lockout.
To reduce the risk of
electrocution, keep well
clear of electric power
lines.
To reduce the risk
of injury from
moving blades or
5m (17ft)
falling cuttings, do
not allow
bystanders within
5 meters of your own position. To
reduce the risk of damage to property,
also maintain this distance from other
objects (vehicles, windows).
Watch the cutting blades at all times – do
not cut areas of the hedge that you
cannot see.
Be extremely careful when cutting tall
hedges, check the other side of the
hedge before starting work.
The drive motor is not
waterproof. To reduce
the risk of a short circuit
or electrocution, never
work with the power tool
in the rain or in wet or
very damp locations.
Do not leave the power tool outdoors in
the rain.
Take special care in slippery conditions
(ice, wet ground, snow), on slopes or
uneven ground.
HLE 71, HLE 71K