Puky LR M Plus Manual De Instrucciones página 6

Learning bike Loopfiets
and carefully wipe dry using a soft cloth. Keep the vehi-
cle away from corrosion-promoting materials (road salt,
sea water, fertiliser). The vehicle must not be stored in
damp conditions.
As with car tires there is a risk of local decolouration or
staining of the natural rubber when the bike rests on its
wheels in the same position for a long time. Take the
necessary precautions to avoid this.
Unpacking and scope of delivery
Do not use any sharp objects when opening the packag-
ing and removing protective material. By doing so, you
may damage the paint or parts of the vehicle.
• Remove all parts from the packaging.
• Remove the protective material. Keep all packaging
material out of reach of children – there is a risk of
suffocation.
• Examine the package for completeness and proper
condition. If anything is missing, please contact your
dealer before you start to assemble the vehicle.
Scope of delivery (Figure A):
1. Learner bike
2. Handle bar
Assembly
The assembly instructions can be found on the last
pages of this manual.
You require the following tools for assembly
(Figure B):
1. Allen key 5 mm
Small parts which are required during assembly (e.g.
screws and washers) must be kept out of the reach of
small children. There is a danger of suffocation as a result
of swallowing the parts. Also keep all packaging material
out of reach of children.
000134_anleitung_lr_43822_32S_04_2018.indd 6
The bike must be assembled with great caution and by an
adult to avoid any potential subsequent accidents or inju-
ries. Please take a sufficient amount of time to assemble
the bike. Several assembly steps require manual skill and
practice in handling tools (e.g. spanner). Please contact
your dealer or a workshop if you have any questions.
In some cases, it is necessary to tighten screws with a
prescribed torque. This torque value is stated in Newtons
(e.g. 2 Nm). If the torque with which a screw is tightened
is too low, the connection may still be too loose and
therefore unsafe. If the torque is too high, screws and
other parts may be damaged or destroyed.
Figure 1: Insert the handlebar into the steer tube and
tighten the screw. Please pay attention to the marking
of the minimum insertion depth.
Figure 2: After loosening the saddle clamp, you can pull
out the saddle (observe minimum insertion depth!). Then
retighten (5-8 Nm).
The brake on this bike has already been installed and
adjusted by PUKY.
Settings control and fine adjustment of the brake
(V-brake). Only for model LR XL.
Figure 3: Make sure that the brake pads are parallel to
each other and that they are properly aligned with the
rim. This means that the brake pads should rest 1 mm
below the top edge of the rim. If these settings are not
correct, loosen the fastening nut of the brake pad (1) and
align as described above. To do so, pull the brake lever
and re-tighten the fastening nut (5-8 Nm).
Figure 4: Brake cable tension is adjusted at the anchor
nut (A) so that each brake pad maintains a distance of
1.5 mm to the rim. If an adjustment needs to be made,
the protruding wire end should then be refastened
to the brake.
Figure 5: Now centre the brake arms by turning the
adjusting screw. You will need a crosstip screwdriver
for this.
It is important that the brake levers are actuated
several times so that the tension of the brake arms
is evenly distributed to both sides and the settings
take effect. The brake/rim contact must be identical
on both sides.
6
13.11.2018 10:56:04