Reer BeeConnect Plus Instrucciones De Uso página 26

Troubleshooting
Problem
Status LED flashes red when
device is switched on and
signal tone sounds.
Status LED flashes red green
when device is switched off
No connection, Status LED
alternately flashes red and
green when switched on,
with signal tone
No sound transmission des-
pite established connection
No vibration alert
Loud whistling sound
(acoustic feedback)
Signal noise /
Connection interrupted
LED 2–4 light up red
LED 5 lights up green
Snooze music too
loud / too quiet
Intercom function too
loud / too quiet
Baby unit reacts upon
noises that are too quiet
Baby unit only reacts upon
noises that are loud
Parent unit does not emit a
signal tone when the maxi-
mum range is exceeded
Despite an established
connection, the
temperature is not
displayed
26
Possible cause
• Batteries are flat.
• Batteries are charging.
• The maximum range has been exceeded.
• The baby unit is not switched on.
• Baby monitor is in ECO mode and baby unit
is in sleep mode (and thus does not transmit
any signals to the parent unit).
• Volume is switched off.
• The selected/set microphone sensitivity level
is too low.
• Volume is on, vibration alert is only switched
on when volume is turned off.
• The baby unit is too close to the parent unit.
• The baby / parent unit is close to interfering
devices (e.g. microwave) or metal objects.
• The maximum range has been exceeded.
• Batteries in the baby/parent unit are too
depleted.
• The parent unit receives sounds. Depending
on the noise level, one or several LED light
up.
• ECO mode is activated
• Volume on the baby unit set too high/too
low.
• The microphone sensitivity is set too high.
• The microphone sensitivity is set too low.
• Baby monitor is in ECO mode.
• Baby monitor is in ECO mode and thus
only transmits signals when the baby unit
perceives noises.
Action
• Replace/charge the batteries or connect the
unit to the power supply.
• No action required.
• Reduce the distance between the baby unit
and the parent unit.
• Ensure that the baby unit is switched on.
• Briefly set the baby unit to "range alarm" until
the connection has been established or force a
signal transfer by making noises at the baby unit.
• Ensure that the volume has not been turned
down all the way, press the
parent unit several times.
• Switch the microphone sensitivity to "HI".
• Switch off the sound to automatically activate
the vibration alert.
• Increase the distance between the baby unit
and the parent unit.
• Try to find the source of interference and move
the units to a different position.
• Reduce the distance between the baby unit and
the parent unit.
• Replace/charge the batteries and / or connect
the unit to the power supply.
• If necessary, turn up the volume to make sure
that you hear the sounds from your baby.
• No action required.
• Change the volume with the +/– keys on the
baby unit.
• Switch the microphone sensitivity to "LOW".
• Switch the microphone sensitivity to "HI".
• In order to activate the range control, push the
switch on the baby unit to "range alarm".
• Speak into the baby unit or briefly switch to
"range alarm".
key on the