High Altitude Operation - Ryobi RY80518 Serie Manual Del Operador

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

 Keep hose away from hot surfaces and sharp edges.

 Do not pull unit by high pressure hose.

 Do not allow hose to be crushed or wrapped around

objects.

WASHING WITH DETERGENT

See Figure 16.

As sold, this unit is designed for use with "downstream"

pressure washer detergents. To convert for use with

"upstream" detergents, contact an authorized customer

service center for more information.

USE ONLY DETERGENTS DESIGNED FOR PRESSURE

WASHERS. Do not use household detergents, acids, alka-

lines, bleaches, solvents, flammable material, or industrial

grade solutions, which can damage the pump. Many de-

tergents may require mixing prior to use. Prepare cleaning

solution as instructed on the solution bottle. Always test in

an inconspicuous area before beginning.

 Place the detergent injection hose in the bottom of the

detergent bottle / container.

NOTE: The machine setting of this unit is 20:1, which

usually allows the use of 1 gallon pressure washer

detergent without further dilution. Check your detergent

instructions to be sure additional dilution is not necessary.

 Install the blue soap nozzle on the spray wand.

 Squeeze the trigger and wait approximately 5 seconds

for the detergent to appear.

 Spray the detergent on a dry surface using long, even,

overlapping strokes. To prevent streaking, do not allow

detergent to dry on the surface.

Before shutting off the engine:

 Place the detergent injection hose in a bucket of clean

water.

 Spray the clear water through the spray wand until the

bucket is empty.

 If any soap remains in the spray, repeat with a second

bucket of clean water.

 Shut off the engine.

NOTE: Shutting off the engine will not relieve pressure in the

system. Pull trigger to release water pressure.

OPERATION

RINSING WITH THE PRESSURE WASHER

 Turn off the pressure washer and shut off the water

supply. Pull trigger to release water pressure.

 Engage the lock out on the trigger handle by pushing up

on the lock out until it clicks into the slot.

 Remove the nozzle by placing hand over nozzle then

pulling back the quick-connect collar. Place nozzle in the

nozzle storage area on the machine.

 Select the right nozzle for the job. See the chart on the

previous page for selecting the appropriate nozzle.

 Start at the top of the area to be rinsed and work down,

overlapping the strokes.

MOVING THE PRESSURE WASHER

See Figure 17.

NOTE: Never lift or carry this product using the handle.

 Turn the pressure washer off.

 Tilt the machine toward you slightly until it balances on

the wheels then roll the machine to the desired position.

Do not tilt forward or sideways when moving.

 DO NOT attempt to move the unit by pulling on any of

the hoses.