Failure Of The Electronics; Maintenance, Cleaning And Care; Maintenance; Care - Ottobock E-MAG Active Instrucciones De Uso

4.2.2 Failure of the electronics

The E-MAG Active is not vulnerable to failure. However, should disruptions occur, the electronics
recognizes the failure and sends a warning signal:
Signal Visual feedback (LEDs)
Electronics
Continuous light
failure (all LEDs except for green)
In the case of such a failure, the E-MAG Active knee joint can only be opened manually (see
section 4.1.3).

5 Maintenance, Cleaning and Care

With the E-MAG Active you have acquired a modern electronic device. In order to benefit from
this sophisticated technology for as long as possible, please observe the following instructions.

5.1 Maintenance

Have your E-MAG Active checked for any wear as well as for proper function of the electronic
components by your orthotist every six months.

5.2 Care

1. Keep your orthosis away from environments with high humidity. Use a slightly moistened cloth
to clean the orthosis, E-MAG Active or any of the components from outside.
2. Since the E-MAG Active is a closed locking system, clothing fibers cannot get into the mecha-
nism. However, please observe the maintenance intervals of six months, because particulate
matter can settle in the electronics and mechanism and can disturb the E-MAG Active.
6 Technical Data & Accessories
Humidity for both ranges
Power supply for joint
Distance range
NOTICE
Only accessories that have been approved for the E-MAG Active system should be used.
18 | Ottobock
Acoustic feedback
Temperature range
Storage
+70°C
(176°F)
-20°C
(-4°F)
0% to 100%
NiMh battery, 4.8V nominal voltage
approx. 5,000 steps corresponding to approx. 5 km
(3.1 miles)
Sound/length
High/
continous tone
Operation
+50°C
(122°F)
-15°C
(5°F)
E-MAG Active