Testing And Adjustment; Care & Cleaning - Toto EcoPower Serie Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

„ Turn on the water supply.

ƒ Turn on the water supply at the stop valves and inspect all the

connections for any leaks (see Ill. 1).

„ Flow Rate Adjustment.

ƒ IMPORTANT: The EcoPower Automatic Faucets must be used

with the stop valves fully opened whenever possible. Insuffi-

cient flow rate will result in power shortage and consumption of

the built-in backup battery.

ƒ If flowrate adjustment is necessary because the wash basin

is too small or the water pressure is too high, turn the stop

valve(s) clockwise to limit the flow. Confirmation of wash basin

specifications is highly recommended before installation of the

Automatic Faucet.

„ Temperature Adjustment (thermal mixing models only).

ƒ The water temperature has been factory set at 100°F (38°C,

Max: 42°C ± 3°C). Depending on the supply water pressure and

other local conditions, the water temperature may not be kept

as specified. In such a case, adjust the temperature by turning

the temperature control handle (see Ill. 2).

ƒ NOTE: If turning the temperature control handle changes the

temperature opposite of the direction indicated, make sure the

hot water supply is connected to the left inlet bracket.

„ Spout and Sensor

ƒ IMPORTANT! Do not scratch the sensor when cleaning the

spout (see Ill. 1).

ƒ Avoid using any cleaning materials that may scratch the spout

surface.

ƒ Never use polishing powder, detergent that includes coarse

particles, thinners, benzene, acids, alkaline detergents, or nylon

scrub brushes, as they can damage the surface of the spout.

ƒ To safely clean the surface, wipe it using a dampened soft cloth

with diluted dishwashing detergent and dry it with another soft

cloth. If this does not adequately clean the surface, wipe the

area with a neutral detergent and wet cloth.

„ Drain (Ryohan only)

To remove the drain cup for cleaning (see Ill. 2):

1. Pull the drain cup unit firmly to the drain part, then release it.

2. Turn the drain cup unit clockwise 45 degrees.

3. Pull the drain cup upwards and out.

NO TE: If the drain cup unit does not come out, put it back and

while turning it clockwise once again, slowly pull it out.