Safety Instructions; Starting Procedure - Gesipa AccuBird Pro Instrucciones De Manejo

1.5

Safety instructions

Caution:
The following safety rules must be observed for adequate protection against electric
shocks, injuries or fire hazards:
• The blind riveting tool should be used exclusively to set blind rivets!
• Do not overload the tool; work within the prescribed work capacity.
Neverusetheblindrivetingtoolinahumidorwetenvironmentorclosetoinflammable
•
substances or gases. Risk of explosion!
• Ensure that the battery is properly secured in the grip.
• Remove the battery when the blind riveting tool is not in use and for repair/servicing
operations.
• Do not use the blind riveting tool as a hammer.
• When not in use, keep the blind riveting tool in a dry, closed room and out of the reach of
children.
• When working with the tool, always wear protective goggles. Personal protection like
clothes, gloves, safety helmet, non-slip shoes, ear protection and anti-fall protection are
highly recommended.
• The air inlets for the motor should not be obstructed. Do not introduce anything into them.
• When setting the blind riveting tool down, make sure that it cannot fall.
• Use only genuine spare parts for repair.
• Repair work must be carried out by skilled workers. In case of doubt, always send the
blind riveting tool back to the manufacturer.
• Do not use the tool outside of riveting holes! The blind rivet could be ejected from the
tool! Never turn the tool towards yourself or towards another person!
• The mandrel container (n° 45) must be mounted on the blind riveting tool tool during
operation.
1.6

Starting procedure

• Insert fully charged battery in correct position into housing.
• Select correct nosepiece according to table 1.4.
• To screw in the nosepiece, activate the switch and proceed until the stop position has
been reached at the back.
• Then remove the battery. Screw in the nosepiece and tighten it using the wrench
provided. Put the battery back in and activate the switch.
GB
21