Festool TURBO II M - 8 WP R1 Manual De Instrucciones página 24

Turbo II M
GB
Failure code Failure D
E
F3 Temp. sen-
sor s
F3 Temp. sen-
sor w
F4
Temp. high
F5 Temp. low
F6 Temp. sen-
sor
F7 Pressure
sensor
F8 Control sys-
tem
F9 Electronics
F10 FI
F11 UI
F12 Temp. high
F13 Calib. P
F13 Start P
F14 Temp. sen-
sor
F15 ON button
Other failures
Failure
No function
24
Significance
Temperature sensor short circuit in
motor winding
Temperature sensor wire break in
motor winding
Temperature in motor terminal box
too high
Device temperature too low
Temperature sensor in terminal box
defective.
Pressure sensor defective
Control system failure
Electronics failure
Failure messages that are by issued
by FI.
Communication failure between user
interface (display) and control system
Temperature of blower nozzle too
high
Pressure sensor calibration failure
Residual vacuum in the system too
high when starting
Temperature sensor at blower nozzle
defective
ON button fault
Cause
Mains supply defective
Fuses have tripped
ground fault circuit interrupter has
tripped
Solution
Contact Service.
Contact Service.
Allow to cool down, provide
improved cooling.
If the problem recurs, contact Ser-
vice.
Increase ambient temperature.
If the problem recurs, contact Ser-
vice.
Contact Service.
Check/replace vacuum hoses.
If the problem recurs, contact Ser-
vice.
Contact Service.
Contact Service.
Contact Service.
Check/replace connection cable.
If the problem recurs, contact Ser-
vice.
Allow to cool down, provide
improved cooling.
If the problem recurs, contact Ser-
vice.
Attempt to start again.
If the problem recurs, contact Ser-
vice.
Attempt to start again.
If the problem recurs, contact Ser-
vice.
Contact Service.
Contact Service.
Solution
Check, repair if necessary.