Idiomas disponibles
Idiomas disponibles
DM 2610922740 8-04 E.qxd
Installing Blade
WARNING
!
blade or making any adjustments.
1. Insert the blade fully into the saw open-
ing until it bottoms in the tool.
2. Secure the blade in the saw using the
Allen wrench to tighten the setscrew.
NOTE: Blade can be mounted with teeth fac-
ing either direction.
WARNING
!
your hand. Blocking the air vents could
cause the motor to overheat.
Operating Speeds
The speed of your saw is variable from 550 -
3900 SPM (strokes per minute).
The footplate tilts in order to keep as much of
the surface in contact with the work surface.
Keep the saw footplate firmly against the
work to minimize counterforce (jumping) and
vibration.
Using the Saw
1. Securely clamp the work.
2. Mark the line of cut and grasp the tool
with one hand on the rotary tool, and the
other hand firmly grasping the insulated
rubber housing on the saw.
WARNING
!
front housing. If you saw into a blind area
where live wiring exists, you may be
shocked or electrocuted.
3. Turn the rotary tool on and let the saw
reach full speed before starting the cut.
Guide the saw so the blade will move
along the marked line.
8/10/04
8:20 AM
ASSEMBLY (CONTINUED)
Unplug tool from power
source before changing
OPERATION
When holding tool, do not
cover the air vents with
Footplate
Always hold the saw by
the insulated grip on the
Page 6
Make sure front end of
WARNING
!
blade extends through the
footplate for the entire stroke length. Do
not use specialty blades that are very
short or those with a significant cant.
Blade must not contact footplate. A blade
which is too short or canted, could jam
inside the footplate and snap.
Higher speed settings are generally used for
fast cutting, or when cutting softer materials
such as wood, composite materials, and
plastics. Slower speed settings are generally
used when precision is required, or when cut-
ting harder materials.
NOTE: If the tool is "chewing" rather than cut-
ting the material, use a higher speed setting.
6
6 6
Capítulos
