Kenwood KDC-X569 Manual De Instrucciones página 33

■ Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main unit so that it
does not fall off.
1
Refer to the section <Removing the hard rubber frame> (page
34) and then remove the hard rubber frame.
2
Drop open the faceplate by pressing the Release button.
3
Tighten the screws (ø2.6 × 12 mm) (Accessory
shown on the diagram.
4
Tighten the screws (ø2 × 4 mm) (Accessory
shown on the diagram.
5
Tighten the screws (ø2 × 6 mm) (Accessory
shown on the diagram.
) in the holes
5
Accessory5
Never insert the screws in any other screw hole than the one specified.
If you screw them in another hole, it will contact and may cause
damage to the mechanical parts inside the unit.
) in the holes
6
Accessory6
— 33 —
) in the holes
7
Accessory7