Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Customer Assistance - Bosch GAM220MF Professional Manual Original

OBJ_BUCH-958-001.book Page 20 Friday, April 17, 2009 1:20 PM
20 | English
"4. BVL": Determining the Bevel Angle
Press button 11 again. "BVL" and the calculated bevel angle
for the chop and mitre saw are indicated on the display.
Notes on "Compound Mitre" Operating Mode
When the spring angle ("SPR") or the corner angle
("CNR") are greater than 180°, the error indication
"– – – –" will be indicated on the display after pressing
button 10 for two seconds; afterwards, the measuring tool
will change to the "normal measuring mode".
The calculated mitre angle "MTR" can only be taken over
for chop and mitre saws, for which the setting for vertical
cuts is 0°. When the setting for vertical cuts is 90°, the
angle for the saw must be calculated as follows:
90° – indicated "MTR" angle = angle to be set on the saw.
If required, the mitre and bevel angle can be recalled again,
but only as long as button 10 for changing the operating
mode has not been pressed. Press button 11 to recall the
angles. "MTR" and the calculated mitre angle are indicated
in the display; after pressing the button once more, 11
"BVL" and the bevel angle will be indicated.
Press button 10 less than 1 s to switch back from "com-
pound mitre mode" to "normal measuring mode".

Maintenance and Service

Maintenance and Cleaning

Keep the measuring tool clean at all times.
Do not immerse the measuring tool into water or other
fluids.
Wipe off debris using a moist and soft cloth. Do not use any
cleaning agents or solvents.
When the measuring tool is exposed to rain for an ex-
tended period, its function may be impaired. However,
after completely drying off, the measuring tool is ready for
operation. No calibration is required.
If the measuring tool should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an authorized after-sales service centre for
Bosch power tools. Do not open the measuring tool your-
self.
In all correspondence and spare parts orders, please always
include the 10-digit article number given on the type plate of
the measuring tool.

After-sales Service and Customer Assistance

Our after-sales service responds to your questions con-
cerning maintenance and repair of your product as well as
spare parts. Exploded views and information on spare
parts can also be found under:
www.bosch-pt.com
Our customer consultants answer your questions con-
cerning best buy, application and adjustment of products
and accessories.
1 609 929 T80 | (17.4.09)
BVL BVL
Bosch Power Tools