Troubleshooting - Samsung POWERbot SR1AM70 Serie Manual De Usuario

Troubleshooting

Symptom
The POWERbot is not
working at all.
The POWERbot has stopped
during cleaning.
Suction power is weak.
The POWERbot cannot find
the docking station.
The POWERbot suddenly
cleans diagonally.
Point cleaning is not
working.
1_VR7000_EN_DJ68-00763C-10_USA.indd 36
fCheck if the emergency switch is on.
fCheck if all the icons are displayed on the display panel.
fCheck if the POWERbot's battery is depleted.
– If "Lo" is displayed, place the POWERbot in the docking station to
charge it.
– If the battery indicator is blinking, manually place the POWERbot
in the docking station to charge. (SR1AM7010U✴ series only)
fReplace the batteries (AAA type) if the remote control is not working.
fIf "Lo" is displayed on the display panel, place the POWERbot in the
docking station to charge it.
fIf the battery indicator is blinking, manually place the POWERbot in
the docking station to charge. (SR1AM7010U✴ series only)
fIf the POWERbot is immobilized by an obstacle such as a cord,
threshold etc, pick it up and move it away from the obstacle.
– If any fabric or string is caught in a drive wheel, turn off the
emergency switch and remove the fabric or string.
fWhen there's too much dust in the dustbin, suction power may be
weakened. Turn off the emergency switch, and then empty the
dustbin.
fIf the intake (on the bottom of the POWERbot) is blocked by foreign
matter, turn off the emergency switch, and then remove the foreign
matter from the intake.
fWhen noise suddenly increases, turn off the emergency switch, and
then empty the dustbin.
fCheck if there's a power failure or whether the power plug is
unplugged.
fRemove any obstacles around the docking station that may prevent
the POWERbot from returning to the docking station.
fIf there's foreign matter on the charging pins, charging can be
affected. Clean the foreign matter off the pins.
fCheck if the docking station is installed along the grain of a wooden
or tile floor.
fThe POWERbot may clean in a diagonal direction if it is moving to
another area using the shortest route. It may also move at a diagonal
if it made contact with an obstacles at that angle, if it was charged
at the docking station at an angle, or if the grain of the wooden/tile
floor is skewed in that direction.
fIf you point the red light directly at the POWERbot, it may not move
in desired direction.
– Point the red light on the floor within 1.6 ft (0.5 m) of the
POWERbot.
✻ ✻ Do not use point cleaning in direct sunlight, under bright light, or on
dark floors.
ENGLISH-36
Checklist
2017-12-01 오후 4:46:43