Use And Maintenance - Jay Fit Manual De Instrucciones

ENGLISH
The owner of this equipment is responsible for making sure that it
has been set up and adjusted by an Authorized Dealer under the
advice of a healthcare professional. The back and hardware may
require periodic safety and function checks. Adjustments should
be performed by your Authorized Dealer. Always use parts
and/or accessories that have been recommended or approved by
Sunrise Medical.
A. MAINTENANCE AND CLEANING
1. Proper maintenance and cleaning will improve performance
and extend the useful life of your equipment.
2. Clean your equipment regularly. This will help you find loose
or worn parts and make your equipment easier to use. You
will need a mild detergent solution and cleaning rags.
3. If discovered, have loose, worn, bent or damaged parts
replaced before using the seating system.
B. CRITICAL SAFETY CHECKS
1. Fasteners:
Sunrise Medical recommends that all fasteners be checked for
wear, such as loose bolts or broken components Every 6 months.
Loose fasteners should be retightened according to the installation
instructions. Contact your Authorized Dealer immediately to
replace any components. Do not continue to use the system after
identifying loose or broken components.
C. EASY CLEANING
1. Back and Cushion cover
a. Remove the cover from backshell by detaching the Velcro
Unzip the zipper on the bottom of the cover.
b. Remove the foam and turn the cover inside out.
c. Zip the cover closed to avoid snagging.
d. Machine wash in warm water (50°C).
e. Drip and tumble dry in on Low Heat.
NOTE – Do not dry clean covers or use industrial washers or dryers to
clean covers. Do not steam autoclave. Do not bleach. Laundry care sym-
bol definitions are shown.
2. Back shell
a. The backshell should be wiped clean with soap and water on
a regular basis to prevent buildup of dirt and grime.
3. Positioning components
a. Remove the components one at a time, noting the place-
ment for re-assembly.
b. Positioning components can be wiped clean with soap and
water.
c. DO NOT immerse positioning components underwater.
Laundry Care Symbols
Machine wash in warm water (50° C)
Only non-chlorine bleach, when needed
Drip dry
Do not iron
Do not dry clean
WARNING
D. WHEELCHAIR DIMENSIONS
1. The JAY Fit is designed to replace the wheelchair's sling
™
upholstery. Prior to installation determine if the wheelchair
used has compatible back canes, by measuring the width
between your back canes as seen in (Fig. 5).
2. Next check that the back canes are a compatible diameter.
The JAY Fit hardware can be mounted on wheelchair back
™
canes ranging from 3/4" to 1 1/8". Measure your back cane
diameter (Fig. 6) and refer to Table 2 to ensure your back
canes are compatible.
3. If you cannot determine that the back canes are compatible
please contact your authorized Sunrise Medical provider
or Sunrise Medical customer service.
TABLE 2
JAY Fit Width
(all contours)
10" - 18"
®
.
JAY Fit Back Width*
(all contours)
10"
12"
8
14"
16"
18"
7
IV. USE AND MAINTENANCE
9 10
Cane diameter (B)
Minimum width Maximum width
inch cm inch
3/4 1.9 1 1/8
Width of back canes from outside
to outside of the tubes (A)
Minimum width Maximum width
inch cm inch
9.7 24.6 12.3
11.7 29.7 14.3
13.7 34.9 16.3
15.7 40.0 18.3
17.7 45.1 20.3
MK-100292 Rev B
9
cm
2.85
10
cm
31.2
36.3
41.3
46.4
54.5