Cleaning The External Surfaces; Cleaning The Control Panel; Cleaning The Nozzles; Disinfecting The External Surfaces - Mocom Millwashing Manual Del Operador

Cleaning the
external surfaces
Cleaning the
control panel
Cleaning the
nozzles
Rotating arm
Rotating arm
Filter and solids
container
Disinfecting the
external surfaces
Cleaning/replacing
the handpiece and
accessory holder
Clean all external surfaces with a clean cloth dampened with water, possibly adding
weak neuter detergent.
Wipe all surfaces and remove any residue before using the unit again.
Clean the control panel with a soft clean cloth dampened with a product for plastic or
other disinfectant suitable for this use.
To eliminate scale traces from the nozzles of the rotating arms, use a clean cotton cloth
soaked with a weak solution of water and vinegar (or similar product, after first
checking its contents on the label).
-
Remove the washing arms.
-
To make the cleaning of the arms inside easier, unscrew and remove the two
caps placed at their ends.
-
Remove any scale residue.
To disinfect external
surfaces use denatured alcohol or products composed with a minimum percentage of
sodium hypochlorite.
Separate the parts that make up the handpiece holders and place all the accessories in
a container filled with a weak solution of water and vinegar. Let the solution dissolve
the scale deposits. Wash under current water and dry.
Replace the internal filter of the handpiece holder if it is no longer recoverable.
Filter
Caps
1
2
3
Salt container
21