Air Cleaner; Low Profile Types - Honda iGX270 Manual Del Propietário

AIR CLEANER

A dirty air cleaner will restrict air flow to the carburetor, reducing
engine performance. If you operate the engine in very dusty areas,
clean or replace the air filter more often than specified in the
MAINTENANCE SCHEDULE.
Operating the engine without an air filter, or with a damaged air
filter, will allow dirt to enter the engine, causing rapid engine wear.
This type of damage is not covered by the Distributor's Limited
Warranty.
Inspection (standard types)
Remove the air cleaner cover and inspect the filter elements.
Clean or replace dirty filter elements. Always replace damaged filter
elements.
Cleaning (standard types)
1. Remove the nut from the air
cleaner cover, and remove the
cover.
2. Remove the wing nut from the
air filter, and remove the filter.
3. Remove the foam filter element
from the paper air filter
element.
4. Inspect both air filter elements,
and replace them if they are
damaged. Always replace the
paper air filter element at the
scheduled interval (see page 7).
5. Clean the filter elements if they are to be reused.
Paper filter element: Tap the filter element several times on a
hard surface to remove dirt, or blow compressed air [not
exceeding 207 kPa (2.1 kgf/cm
element from the inside. Never try to brush off dirt; brushing
will force dirt into the fibers.
Foam filter element: Clean in warm soapy water, rinse, and
allow to dry thoroughly. Or clean in non-flammable solvent and
allow to dry. Dip the filter element in clean engine oil, and then
squeeze out all excess oil. The engine will smoke when started
if too much oil is left in the foam.
Clean Squeeze and Dry
Do not twist.
10
NUT
AIR CLEANER
COVER
WING NUT
PAPER AIR
FILTER ELEMENT
FOAM FILTER
ELEMENT
AIR CLEANER
GASKET
CASE
2
, 30 psi)] through the filter
Dip in Oil Squeeze
Do not twist.
6. Wipe dirt from the inside of the air cleaner case and cover using
a moist rag. Be careful to prevent dirt from entering the air duct
that leads to the carburetor.
7. Place the foam filter element over the paper air filter element,
and reinstall the assembled air filter. Be sure the gasket is in
place beneath the air filter. Tighten the air filter wing nut
securely.
8. Install the air cleaner cover, and tighten the nut securely.
Inspection (low profile types)
Remove the air cleaner cover and inspect the filter element.
Visually inspect the filter element. Clean the foam filter element.
Always replace damaged filter element.
Cleaning (low profile types)
1. Unsnap the air cleaner cover clips and remove the air cleaner
cover.
2. Remove the foam filter element from the air cleaner case.
3. Inspect the foam filter element, and replace it if it is damaged.

LOW PROFILE TYPES

AIR CLEANER CASE
FOAM FILTER
ELEMENT
4. Clean the foam filter element if it is to be reused.
Clean in warm soapy water, rinse, and allow to dry thoroughly.
Or clean in non-flammable solvent and allow to dry.
Dip the filter element in clean engine oil, then squeeze out all
excess oil. The engine will smoke when started if too much oil
is left in the foam.
Clean Squeeze and Dry
Do not twist.
5. Wipe dirt from the inside of the air cleaner case and cover,
using a moist rag. Be careful to prevent dirt from entering the
air duct that leads to the carburetor.
6. Install the foam filter element to the air cleaner case.
7. Install the air cleaner cover and snap the air cleaner cover clips.
ENGLISH
CLIP
AIR CLEANER COVER
Dip in Oil Squeeze
Do not twist.