AirSep Focus Manual Del Paciente página 164

Focus™
2) Connecting Focus to a DC power source:
The universal power supply can also be used to operate the Focus unit from
any 12-Volt DC power source. For example: to a car, (boat, motor home,
etc.) with a 12-Volt DC socket. Connect the power supply cord labelled DC
OUT to Focus into the Focus unit's power inlet, as shown in Figure 8. Place
the DC accessory adapter on the end of the DC power cord. Connect the
other end into the power supply input connection labelled Accessory DC IN.
You can then connect the DC power cord (with adapter attached) into the
12-Volt DC power source. Do not force the cords, as they can be inserted
only one way.
Connect to
Focus
Accessory
DC IN
3) Connecting Focus with the Battery, as shown:
Before using the battery, check that it has a sufficient charge. The battery is
equipped with a gauge (Figure 9) to indicate the level of battery charge (25-
100%). To check the level of charge of the battery, press the button on the
battery's keypad. The battery gauge/indicator(s) LEDs to the left of the
button illuminate to indicate the level of battery charge (25-100%). Connect
the switch end of the battery cord into the Focus unit's power inlet only, as
shown in Figures 5 and 6. Connect the other end into the battery. Do not
force the cords, as they can only be properly inserted one way. Refer to the
instructions on charging the battery in the Battery Charging section.
®
AirSep Corporation
MN172-1 rev. - 03/11
Figure 8
GB
DC OUT
to Focus
DC accessory
adapter
Connect
to Focus
GB-12