Cleaning And Care; Troubleshooting - OK. OKR 120 Manual De Instrucciones

EN

CLEANING AND CARE

• Disconnect the product from the power supply before cleaning it. Clean the product with a soft, damp
cloth and a mild cleaning agent. Finish by wiping it with a dry cloth. Do not use alcohol, acetone,
benzene, scouring cleansers etc. to clean the product. Do not use hard brushes or metal objects.
• Warning! Never immerse electrical parts of the product in water during cleaning or operation. Never
hold the product under running water.
• Warning! When cleaning, never use solvents or abrasive materials, hard brushes, metallic or sharp
objects. Solvents are harmful to human health and can attack plastic parts, while abrasive cleaning
mechanisms and tools may scratch the surface(s).

TROUBLESHOOTING

If there are any problems during operation, please refer to the following table. If problems cannot be
solved as indicated under Solution, please contact your manufacturer.
Problem
Product does not function
No Sound
No radio reception
SPECIFICATION
Power supply
Operation power consumption : 3.5 W
Standby-power consumption
Backup-Batteries operation
Tuning-range
Tuning grid
Protection class
DISPOSAL
The crossed-out wheeled bin logo requires the separate collection of waste electric and
electronic equipment (WEEE). Electric and electronic equipment may contain dangerous and
hazardous substances. Do not dispose of this appliance as unsorted municipal waste. Return it
to a designated collection point for the recycling of WEEE. By doing so, you will help to conserve
resources and protect the environment. Contact your retailer or local authorities for more
information.
Please dispose of batteries in an environmentally friendly manner. Do not put batteries into the
household waste. Please use the return and collection systems in your community or contact
the dealer where you purchased the product.
IM_OKR120_170824_V03_HR.indb 14
14
Possible causes
• Interrupted power supply
• Volume is very low
• Poor radio reception
: 230 V~, 50 Hz
: ≤1 W
: 3 V (button cell,type CR2025)
: 88 - 108 MHz
: 0.1 MHz
: II
Solution
• Check the power supply
• Adjust the volume
• Place the product to another
place and adjust the antenna
again.
24/8/17 5:20 pm