Idiomas disponibles
Idiomas disponibles
3.2.4 LIFT INSTALLATION
The equipment must be stored near the area where it will
be installed.
WARNING! Before beginning work, remove all
obstructions from the installation area.The area
must be appropriately marked to keep non-
authorised personnel out. Check the condition
and suitability of the equipment available.This
is a potentially dangerous operation and must
therefore be performed by skilled responsible
personnel The use of the lifting equipment
must be performed in accordance with the
safety rules in force in the nation where the lift
is being used. Never touch suspended loads
and never stand within the operating radius of
the lift truck.
Take the lift from the warehouse in which it has been
stored since arrival using a fork lift or any other adequate
lifting equipment.
Remove the packaging with the maximum attention and
proceed to the positioning of the equipment by proceeding
as follows:
•
Bring the fork lift near the wooden crate, slide the fork
between the lower part of the lift and the bottom of the
crate.
•
Slowly raise the lift from the crate and position it on the
fl oor in the installation area foreseen, being careful not
to overturn the control console.
•
Take the control console from the movable platform of
the lift and rest it at a certain distance from the lift in a
safe position
•
Unscrew the screws on the control console using
the appropriate setscrew wrench, remove the metal
casing from the control console and the hydraulic unit,
and position it in a safe place (Fig. 3a PONYBENCH
BEPLUS or Fig. 3b PONYBENCH BPPLUS).
•
The PONYBENCH-B is equipped with a single-acting
jack that permits the movable platform to be raised
without using the hydraulic unit.
•
With the movable platform lowered, install 4 lifting
eyebolts in the holes provided at the corners of the
upper movable platform bed.
•
Pass tie-rods with cables or chains through the 4
eyebolts previously prepared on the upper movable
platform bed.
•
Hang the tie-rods from the crane hook and lift slowly
until the lift's upper movable platform is completely
extended. Continue raising until the base is lifted
approx. 20 cm from the fl oor.
•
With the use of the lifting device, insert the lift into
the pit prepared previously, being careful to avoid all
damage.
•
Slowly lower the crane until the anti-fall safety hook
engages the last block provided in the lift base sheet
(which corresponds to the lift's maximum lifting
height).
•
Keep the lift's movable platform hanging from the
crane hook.
Fig. 3a: PONYBENCH BPPLUS CONTROL CONSOLE
�
��
�
�
Fig. 3b: PONYBENCH BEPLUS CONTROL CONSOLE
�
67
CASING
CASING
GB
Capítulos
